EXSYS EX-3515 Manual descargar pdf (Pagina 10)

2-Port SATA3 RAID/HyperDuo PCIe Card

Some broken array is caused by the connection problems. To see if

it is the problem, please power off your computer and check the

cable connections between the RAID card and SSD or hard drives.

Or change a new power or SATA cable, then power on the

computer again. These may bring the broken array back to normal

if the root cause is the connection problem.

If the above actions don’t work, then it may be the SSD or hard

drive problem. Please replace the defect drive with a good one.

The RAID card then will detect the new drive and rebuild the broken

array (RAID 1). Please note that you cannot rebuild a broken RAID 0

in any case.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

EXSYS EX-3515 Manual Pagina 10