EXSYS EX-3515 Manual descargar pdf (Pagina 7)

2-Port SATA3 RAID/HyperDuo PCIe Card

To further configure the disk array, use the up or down arrow key to

move the selection bar to select an item in the right block of the

screen and press <Enter>. Set the required items in sequence and

press <Enter> after each step:

1. RAID Level: Select a RAID level. Options include RAID 0 (Stripe)

and RAID 1 (Mirror).

2. Stripe Size: Select the stripe block size. Options include 32 KB

and 64 KB.

3. Gigabyte Rounding: Select whether to permit the installation of

a replacement drive that is smaller than the failed drive when

performing a RAID 1 rebuild. Options include None, 1G, and

10G.

4. Quick Init: Select whether to quickly erase old data on the hard

drives when creating the array.

5. VD Name: Enter an array name with 1~10 letters (letters cannot

be special characters).

6. Next: After completing the settings above, move to Next and

press <Enter> to begin creating the array. When prompted to

confirm whether to create this array, press <Y> to confirm or <N>

to cancel.

7. When completed, you can see the new array under

Topology\Virtual Disks.

8. Save the Settings and Exit. After you complete the RAID

configuration and before you exit the configuration screen, be

1 2 3 4 5 6 7 8 9 10

Sin comentarios

EXSYS EX-3515 Manual Pagina 7